3.12 $JQUERY,GUIDE
This command is used to poll the receiver for its opinion on whether or not
it is providing suitable performance after the both SBAS and GPS have been
acquired (up to 5 min). This feature takes into consideration the download
status of the SBAS ionospheric map and also the carrier phase smoothing of
the GPS.
This command has the following format.
$JQUERY,GUIDE<CR><LF>
If the receiver is ready for use with navigation or positioning with optimum
performance, it will return the following message.
$>JQUERY,GUIDE,YES<CR><LF>
Otherwise, it will return the following message.
$>JQUERY,GUIDE,NO<CR><LF>
3.13 $JRESET
This command is used to reset the receiver’s GPS engine(s) to their default
operating parameters.
This message has the following format.
$JRESET<CR><LF>
3.14 $JSAVE
Sending this command is required after making changes to the operating
mode of the receiver in order to ensure the changes are present for the
subsequent power cycle.
To Next Page
Loading...
Need help?
General
