Programming Manual 30
$JATT commands do not require a $JSAVE command to be issued
subsequently as their changes are automatically saved.
This command has the following structure.
$JSAVE<CR><LF>
The receiver will reply with the following two messages. Ensure that the
receiver indicates that the save process is complete before turning the
receiver off or changing the configuration further.
$> Saving Configuration. Please Wait...
$> Save Complete
No data fields are required. The receiver will indicate that the configuration
is being saved and will notify you when the save is complete.
3.15 $JSHOW
This command is used to poll the receiver for its current configuration.
This command has the following structure.
$JSHOW[,subset] <CR><LF>
Using the $JSHOW command without the optional ‘,subset’ field will provide
a complete response from the receiver. An example of this response
follows.
To Next Page
Loading...
Need help?
General
