Note - Please ensure that you save any changes that you wish to
maintain beyond the current power-up by using the $JSAVE
command and wait for the ‘$> Save Complete’ response.
3.1 $JASC,D1
This command allows you to adjust the output of the RD1 diagnostic
information message from the receiver. The diagnostic information is
specific to whichever differential source you are currently using.
This command has the following structure.
$JASC,Dx,r[,OTHER]<CR><LF>
Currently, only the RD1 message is currently defined with x = 1. The
message status variable ‘r’ may be one of the following values.
r Description
0 OFF
1 ON
When the ‘,OTHER’ data field is specified (without the square brackets), this
command will enact a change in the RD1 message on the other port.
3.2 $JAIR
This command allows you to place the primary GPS engine within the
receiver into AIR mode HIGH, where the receiver is optimized for the high
dynamic environment associated with airborne platforms. JAIR defaults to
normal (NORM) and this setting is recommended for most applications.
Turning AIR mode on to HIGH is not recommended for Vector operation.
The format of this command follows.
$JAIR,r<CR><LF>
To Next Page
Loading...
Need help?
General
