Programming Manual 26
9600
19200
38400
When this command has been issued without the ‘,OTHER’ data field, the
baud rate of the current port will be changed accordingly. When the
‘,OTHER’ data field is specified (without the square brackets), a baud rate
change will occur for the other port.
The receiver will reply with the following response.
$>
3.8 $JCONN
This command is used to create a virtual circuit between the A and B port, if
needed. This allows you to communicate through the receiver from Port A
or B to the opposite port.
The virtual circuit command has the following form.
$JCONN,p<CR><LF>
Where the connection type, ‘p’, may be one of the following.
p Description
AB Specify ‘AB’ in order to connect the A port to the B port
X Once a virtual circuit has been established, to remove the
virtual circuit, specify ‘X’ in this command to return the
current port to normal
To Next Page
Loading...
Need help?
General
