If you wish to clear the FLASH configuration, simply issue the following
commands in succession to save the default state into FLASH:
$PCSI,SETUP,RESET<CR><LF>
$PCSI,SETUP,SAVE<CR><LF>
11.10 $PCSI,SETUP,INTRO
To set the introductory display strings that are shown at startup, use the
following command to set the startup screen:
$PCSI,SETUP,INTRO,topline,bottomline
In this message, ‘topline’ is the top line of the display and ‘bottomline’ is the
bottom line of the display.
Spaces and many other characters are permitted in this message. The only
display character not supported is the comma ‘,’ character as it indicates the
beginning of the bottom line text. Each line must be equal to 16 characters in
length or less.
As an example, if the following command was issued:
$PCSI,SETUP,INTRO, CSI Wireless Inc, MAX<CR><LF>
The setup must be saved, using the $PCSI,SETUP,SAVE<CR><LF>
command, in order for the change to remain for the next power cycle. The
respective startup screen would be the following:
CSI WIRELESS INC
DGPS MAX
11.11 $PCSI,SETUP,MUX,
This command is not supported.
To Next Page
Loading...
Need help?
General
