6. OmniSTAR Commands (for
DGPS MAX only)
This section presents the commands supported by the internal OmniSTAR
sensor within the DGPS MAX.
The following table provides a brief description of the commands supported
by the OmniSTAR sensor for its configuration and control.
Table 6-1 OmniSTAR Commands
Message Description
$JLBEAM This command requests the current spot beam tables in use by the OmniSTAR receiver
$JLXBEAM This command requests debug information for the current spot beam tables
$JOMS This command requests the OmniSTAR engine to provide the current subscription information for the
OmniSTAR service.
$JOMR This command requests the OmniSTAR receiver to provide raw OmniSTAR region information.
$JFREQ This command allows you to tune the OmniSTAR receiver either in automatic mode or manually.
$JGEO This command requests information relating to the current frequency and location of the OmniSTAR
satellite in relation the antenna of the DGPS MAX system.
The following subsections provide detailed information relating to the use of
each command.
Note - Please ensure that you save any changes that you wish to
maintain beyond the current power-up by using the $JSAVE
command
6.1 $JLBEAM
This command displays the current spot beams used by the OmniSTAR
receiver inside the DGPS MAX.
To Next Page
Loading...
Need help?
General
