CSI Wireless DGPS MAX Programming Manual

Programming Manual 103
Baud Rates
4800
9600
19200
The MAX will respond by issuing the following message:
$>PCSI,MSG,Baud rate set to xxxx
Where ‘xxxx’ is the new baud rate. Once issued, the DGPS MAX will
change its baud rate to the desired baud rate. Note, the SLX-2 Port B baud
rate does not change, this must be done manually.
11.4 $PCSI,STATUS
This command is not supported by the DGPS MAX.
11.5 $PCSI,SETUP,SET
This command is used to set the MAX’s configuration.
The command follows the following format:
$PCSI,SETUP,SET,dms,ft,spd,utc,diff,hz<CR><LF>
This message is summarized in the following table:

CSI Wireless DGPS MAX Specifications

General

Brand	CSI Wireless
Model	DGPS MAX
Category	Receiver
Language	English