Programming Manual 104
Field Purpose Options Description
dms Lat/Long Format DD Degrees ( dd.ddddd )
DMS Degrees, Minutes, Seconds ( dd mm ss.ss )
DM Degress, Minutes ( dd mm.mmm )
ft Altitude Format FEET Feet
METERS Meters
spd Speed Format KMPH Kilometers per Hour
MPH Miles per Hour
KNOTS Knots per Hour
utc UTC offset -12<x<12 UTC Offset
diff Differential Source NONE Autonomous Mode
BEACON SBX-2, Beacon Mode
LBAND SLX-2, OmniStar Mode
WAAS SLX-2, WAAS Mode
EXTERNAL External RTCM, Port A Mode
hz GPS Update Rate 5 GGA and VTG Information received at 5 Hz.
1 GGA and VTG Information received at 1 Hz
.
An example of the use of this command follows:
$PCSI,SETUP,SET,DMS,FEET,KPH,-7,BEACON,5<CR><LF>
This command will set the unit to Degree-minute-second mode, feet as the
altitude format, kph as the speed format, a UTC offset of –7 hours, using
beacon mode and receiving GPS data at 5 Hz.
11.6 $PCSI,SETUP,SHOW
To see the setup the DGPS MAX currently has, the following command can
be issued:
$PCSI,SETUP,SHOW<CR><LF>
The DGPS MAX will respond by displaying the message similar to the
following:
$>PCSI,Setup,NMEARate,9600
To Next Page
Loading...
Need help?
General
