D-Link DGS-1210-52 User Manual

6 Command Line Interface D-Link Smart Managed Switch User Manual
1
1
4
4
3
3
--- 3000 ::1 Ping Statistics ---
3 Packets Transmitted, 3 Packets Received, 0% Packets Loss
DGS-1210-52MP>
reboot
Purpose To reboot the Switch. If the Switch is a member of a stack, it may
be rebooted individually, without affecting the other members of
the stack.
Syntax
reboot
Description
The reboot command
reboots the system. All network
connections are terminated and the boot code executes.
Parameters None.
Restrictions None.
Example usage:
To restart the Switch:
DGS-1210-52MP> reboot
% Device will reboot, please wait a few minutes to re-login.
DGS-1210-52MP>
reset config
Purpose To reset the Switch to the factory default settings.
Syntax
reset config
Description All configurations will be reset to the default settings.
Parameters
None.
Restrictions None.
Example usage:
To restore all of the Switch’s parameters to their default values:
DGS-1210-52MP> reset config
% Device will reboot after reset configuration successfully.
DGS-1210-52MP>
show boot_file
Purpose To display the information of the boot file on the Switch.
Syntax
show boot_file
Description
The show boot_file command displays the current information of
boot file on the switch.

D-Link DGS-1210-52 Specifications

General

Switching Capacity	104 Gbps
MAC Address Table Size	16K entries
Power Supply	100 to 240 VAC, 50/60 Hz internal universal power supply
Managed	Yes
PoE	No
Humidity	5% to 95% non-condensing
VLANs	4K
Jumbo Frame	9216 Bytes
Dimensions	440 x 44 mm
Operating Temperature	0 to 50 °C (32 to 122 °F)
Storage Temperature	-40 to 70 °C (-40 to 158 °F)
Standards Compliance	IEEE 802.3, 802.3u, 802.3ab, 802.3x, 802.1D, 802.1w, 802.1Q, 802.1p
Ports	48 x 10/100/1000BASE-T, 4 x SFP