D-Link DGS-1210-52 User Manual

6 Command Line Interface D-Link Smart Managed Switch User Manual
144
Parameters None.
Restrictions None.
Example usage:
To the information of the boot file on the Switch:
DGS-1210-52MP> show boot_file
Bootup Firmware : image_1
Bootup Configuration : config_1
DGS-1210-52MP>
show firmware information
Purpose To display the firmware information on the Switch.
Syntax
show firmware information
Description
The show firmware information command displays the current
firmware information on the switch.
Parameters None.
Restrictions None.
Example usage:
To the firmware information on the Switch:
DGS-1210-52MP> show firmware information
IMAGE ONE:
Version : 6.00.005
Size : 12288000 Bytes
Updated Time : 01/01/1970 00:00:00
From : 10.90.90.90
User : Anonymous (unknown)
IMAGE TWO:
Version : 6.00.005
Size : 12288000 Bytes
Updated Time : 01/01/1970 00:00:00
From : 10.90.90.90
User : Anonymous (unknown)
DGS-1210-52MP>

D-Link DGS-1210-52 Specifications

General

Switching Capacity	104 Gbps
MAC Address Table Size	16K entries
Power Supply	100 to 240 VAC, 50/60 Hz internal universal power supply
Managed	Yes
PoE	No
Humidity	5% to 95% non-condensing
VLANs	4K
Jumbo Frame	9216 Bytes
Dimensions	440 x 44 mm
Operating Temperature	0 to 50 °C (32 to 122 °F)
Storage Temperature	-40 to 70 °C (-40 to 158 °F)
Standards Compliance	IEEE 802.3, 802.3u, 802.3ab, 802.3x, 802.1D, 802.1w, 802.1Q, 802.1p
Ports	48 x 10/100/1000BASE-T, 4 x SFP