D-Link DGS-1210-52 User Manual

6 Command Line Interface D-Link Smart Managed Switch User Manual
1
1
4
4
7
7
DGS-1210-52MP> show route ipv6
IPv6 Static Route State : Disable
DGS-1210-52MP>
config account admin password
Purpose To display the configuration of an IP interface on the Switch.
Syntax
config account admin password <passwd>
Description
The config account admin password command
sets the
administrator password.
Parameters
<passwd> − The new password of the administrator.
Restrictions None.
Example usage:
To configure the account admin password:
DGS-1210-52MP> config account admin password 1234
DGS-1210-52MP>
save
Purpose To save changes in the Switch’s configuration to non-volatile
RAM.
Syntax
save
Description
The save command
saves the configuration changes to the
memory.
Parameters None.
Restrictions None.
Example usage:
To save the Switch’s current configuration to non-volatile RAM:
DGS-1210-52MP> save
Building configuration ...
[OK]
DGS-1210-52MP>
debug info
Purpose To display the ARP table and MAC FDB information of the
Switch.
Syntax
debug info

D-Link DGS-1210-52 Specifications

General

Switching Capacity	104 Gbps
MAC Address Table Size	16K entries
Power Supply	100 to 240 VAC, 50/60 Hz internal universal power supply
Managed	Yes
PoE	No
Humidity	5% to 95% non-condensing
VLANs	4K
Jumbo Frame	9216 Bytes
Dimensions	440 x 44 mm
Operating Temperature	0 to 50 °C (32 to 122 °F)
Storage Temperature	-40 to 70 °C (-40 to 158 °F)
Standards Compliance	IEEE 802.3, 802.3u, 802.3ab, 802.3x, 802.1D, 802.1w, 802.1Q, 802.1p
Ports	48 x 10/100/1000BASE-T, 4 x SFP