D-Link DGS-1210-52 User Manual

4 Web-based Switch Configuration D-Link Smart Managed Switch User Manual
76
Figure 4.90 – L3 Functions > IPv4 Static Route – Add
The new entry will be displayed in the IPv4 static route table:
Figure 4.91 – L3 Functions > IPv4 Static Route – Static Route Table
Click the Delete button to remove the entry.
L3 Functions > IPv4 Routing Table Finder
The IPv4 Routing Table Finder page shows the current IPv4 routing table of the Switch. To find a specific
IPv4 route, enter and IPv4 address into the Network Address field and click the Search button.
Figure 4.92 – L3 Functions > IPv4 Routing Table Finder
L3 Functions > IPv6 Static Route
The IPv6 Static Route page allows user to enable and configure the IPv6 route settings.
Figure 4.93 – L3 Functions > IPv6 Static Route
IPv6 Static Route: Specifies to enable or disable the IPv6 static route feature on the Switch.
Click the Apply button to implement changes made.

D-Link DGS-1210-52 Specifications

General

Switching Capacity	104 Gbps
MAC Address Table Size	16K entries
Power Supply	100 to 240 VAC, 50/60 Hz internal universal power supply
Managed	Yes
PoE	No
Humidity	5% to 95% non-condensing
VLANs	4K
Jumbo Frame	9216 Bytes
Dimensions	440 x 44 mm
Operating Temperature	0 to 50 °C (32 to 122 °F)
Storage Temperature	-40 to 70 °C (-40 to 158 °F)
Standards Compliance	IEEE 802.3, 802.3u, 802.3ab, 802.3x, 802.1D, 802.1w, 802.1Q, 802.1p
Ports	48 x 10/100/1000BASE-T, 4 x SFP