DIR-815/AC Wireless AC1200 Dual Band Router
with 3G/LTE Support and USB Port
User Manual
Configuring via Web-based Interface
System Time
On the System / System Time page, you can manually set the time and date of the router or
configure automatic synchronization of the system time with a time server on the Internet.
Figure 165. The System / System Time page.
To set the system time manually, follow the next steps:
1. Move the Enable NTP switch to the left.
2. In the Time Settings section, specify needed values. To specify the time set up your PC or
portable device, click the SET LOCAL TIME button.
3. Click the APPLY button. The System date and System time fields will be filled in
automatically.
To enable automatic synchronization with a time server, follow the next steps:
1. Move the Enable NTP switch to the right.
2. Specify the needed NTP server or leave the value specified by default in the NTP Servers
section. If you need to specify several servers, click the ADD SERVER button.
3. Select your time zone from the Timezone drop-down list in the NTP Settings section. To
set the time zone in accordance with the settings of your operating system or portable
device, click the DETERMINE TIMEZONE button.
4. Click the APPLY button. The System date and System time fields will be filled in
automatically.
To enable automatic adjustment for daylight saving time of the router, move the Daylight saving
time switch to the right in the NTP Servers section and click the APPLY button.
In some cases NTP servers addresses are provided by your ISP. In this case, you need to move the
Get NTP server addresses using DHCP switch in the NTP Servers section to the right and
click the APPLY button. Contact your ISP to clarify if this setting needs to be enabled. If the Get
NTP server addresses using DHCP switch is moved to the right, the NTP Servers section is
not displayed.
Page 211 of 221
To Next Page
Loading...
Need help?
General
