D-Link DSL-124 User Manual

82D-Link DSL-124 Wireless N300 ADSL2+ Modem Router User Manual
Section 4 - Conguration
MAC Filter
Outgoing Default
Action:
Select whether to Deny or Allow frames to ow out of the WAN
interface. The default setting is Allow.
Incoming Default
Action:
Select whether to Deny or Allow frames to flow into the WAN
interface. The default setting is Allow.
DEFAULT POLICY
CURRENT MAC FILTER TABLE
The current list of MAC lters are displayed here. To delete a lter, select it from the list and
click Delete. To delete all the lters, click Delete All.
Direction: Select whether this rule will apply to Outgoing or Incoming trac.
Action: Select whether to Deny or Allow frames.
ADD FILTER
To create a rule, ll out the following parameters.
Source MAC: Enter the source MAC address to lter.
Destination Mac: Enter the destination MAC address.
You may create a rule to apply to either a Source MAC address, Destination MAC address,
or both. Broadcast MAC addresses may not be ltered.
When you are satised with your MAC Filtering rule, click ADD.
The MAC filter is used to restrict or allow certain types of Ethernet Frames through the
gateway based on their source or destination MAC address. These filters are helpful in
securing or restricting traffic on your local network.

D-Link DSL-124 Specifications

General

Brand	D-Link
Model	DSL-124
Category	Network Router
Language	English