D-Link ShareCenter Pulse DNS-320 User Manual

59D-Link ShareCenter Pulse DNS-320 User Manual
Section 4 - Conguration
Network Management
LAN Setup
¢
he LAN Settings allows you to enable LLTD and to congure the Link Speed and the IP address as a DHCP client or Static IP.
£¤¥¦ ¥
lient:
§
electing DHCP Client will cause the DNS-320 to obtain an IP address
from the local DHCP server.
¨
tatic IP:
§
electing Static IP requires you to assign the IP information for the
DNS-320 manually.
©¦ ª
ddress:
«¬
ter an IP address for your device. The IP address of each device
on the local area network must be within the same IP address range
and subnet mask.
¨
®¯°± ²
ask:
«¬
ter the Subnet Mask. The default subnet mask is 255.255.255.0.
³
ateway IP
Address:
«¬
ter the Gateway IP Address for the device. The Gateway IP Address
is almost always the LAN address of your router. Most D-Link routers
have a default LAN IP address of 192.168.0.1.
£´¨µ¶ £´¨·¸ §¹º»¼½¾
the rst and second DNS Addresses for the device. The rst
DNS address is usually the LAN address of your router. A DNS Address
will allow the device to resolve names into IP addresses. Click Save
Settings when nished
IP Settings

D-Link ShareCenter Pulse DNS-320 Specifications

Power

power supply	External Power Supply
power consumption (normal mode)	15.7 W
power consumption (sleep mode)	8.2 W

Operating Environment

operating temperature	0˚ to 40˚ C (32˚ to 104˚ F)
storage temperature	-20˚ to 70˚ C (-4˚ to 158˚ F)
operating humidity	5% to 90% (Non-condensing)

Ports & Interfaces

ethernet port	10/100/1000 Gigabit Ethernet Port
usb port	1 USB 2.0 Port
supported hard drive type	3.5” Internal SATA (Maximum HDD Capacity: 2 TB for each drive)

Weight and Dimensions

dimensions	146.4 x 115 x 178.5 mm (5.8 x 4.5 x 7.0 inches)
weight	0.85 kg (1.87 lbs)