To Next Page

To Previous Page

Parameter Description

Enable ARP/Ping to set IP

address service

Select the check box, get the camera MAC address, and then you can

modify and congure the device IP address with ARP/ping command.

This is enabled by default. During reboot, you will have no more than 2

minutes to congure the device IP address by a ping packet with

certain length, the server will be turned o in 2 minutes, or it will be

turned o immediately after the IP address is successfully congured. If

this is not enabled, the IP address cannot be congured with ping

packet.

A demonstration of conguring IP address with ARP/Ping.

1. Keep the camera that needs to be congured and the PC within the

same local network, and then get a usable IP address.

2. Get the MAC address of the camera from device label.

3. Open command editor on the PC and enter the following

command.

4. Restart the camera.

5. Check the PC command line, if information such as Reply from

192.168.0.125… is displayed, the conguration succeeds, and you

can turn it o then.

6. Enter http://(IP address) in the browser address bar to log in.

Step 3 Click Save.

4.6.2 Port

Congure the port numbers and the maximum number of users (includes web, platform client, and

mobile phone client) that can connect to the device simultaneously.

Procedure

Step 1 Select Setting > Network > Port.

Operation Manual

Dahua IPC-HFW2431T-ZS-S2 User Manual

Other manuals for Dahua IPC-HFW2431T-ZS-S2