SiUS041111 Indoor Unit: 15/18/24 Class
Removal Procedure 157
2.4 Removal of Electrical Box / PCBs / Swing Motors
Procedure Warning Be sure to wait for 10 minutes or more after turning off all power supplies
before disassembling work.
Step Procedure Points
1. Remove the electrical box. Preparation
Remove the front grille
according to the “Removal of
Front Grille”.
1
Remove the screw and
remove the drip proof
plate.
2
Cut the clamp.
3
4
5
Pull out the indoor heat
exchanger thermistor.
Remove the screw of
the ground.
Remove the screws of
the connection wires.
Be careful not to lose the clip for
the thermistor.
To Next Page
Loading...
Need help?
General
