Output Sequence Overview
Product Reference Guide 3-19
5. End Output Sequence Editor
Scan F F to enter an Output Sequence for an additional symbol-
ogy, or Save to save your entries.
Other Programming Selections
Discard
This exits without saving any Output Sequence changes.
Output Sequence Examples
In this example, you are scanning Code 93, Code 128, and Code 39 bar
codes, but you want the imager to output Code 39 1st, Code 128 2nd,
and Code 93 3rd, as shown below.
You would set up the sequence editor with the following command line:
SEQBLK62999941FF6A999942FF69999943FF
NOTE
Code 93 must be enabled to use this example.
A - Code 39
B - Code 128
C - Code 93
To Next Page
Loading...
Need help?
General
