Fax Receive Settings
Menu item Description
Enable Fax Receive
On
Off
Allows fax jobs to be received by the printer
Note: On is the factory default setting.
Fax Job Waiting
None
Toner
Toner and Supplies
Allows a fax to be held until toner or supplies are replaced
Notes:
• This menu item appears only if a hard disk is supported and installed.
• None is the factory default setting.
Rings to Answer
1–25
Specifies the number of rings before answering an incoming fax job
Note: 3 is the factory default setting.
Auto Reduction
On
Off
Scales an incoming fax job so it fits the size of the paper loaded in the designated
fax source
Note: On is the factory default setting.
Paper Source
Auto
Tray <x>
Multi-Purpose Feeder
Specifies the paper source selected to supply paper for the printer to print an
incoming fax
Note: Auto is the factory default setting.
Separator Sheets
None
After job
Before job
Places a sheet of paper before or after a received fax.
Note: None is the factory default setting.
Separator Sheet Source
Tray <x>
Manual feeder
Specifies a paper source.
Note: Tray <x> is the factory default setting.
Sides (Duplex)
On
Off
Enables duplex printing (two-sided printing) for incoming fax jobs
Note: Off is the factory default setting.
Fax Footer
On
Off
Prints the transmission information at the bottom of each page from a received fax
Note: On is the factory default setting.
Max Speed
2400
4800
9600
14400
33600
Specifies the maximum speed in baud at which faxes are received
Note: 33600 is the factory default setting.
Fax Forwarding
Forward
Print
Print and Forward
Enables forwarding of received faxes to another recipient
Understanding printer menus
198
To Next Page
Loading...
Need help?
General
