Additional printer setup
Installing internal options
CAUTION—SHOCK HAZARD: If you are accessing the system board or installing optional hardware or memory
devices sometime after setting up the printer, then turn the printer off, and unplug the power cord from the
wall outlet before continuing. If you have any other devices attached to the printer, then turn them off as well,
and unplug any cables going into the printer.
You can customize your printer connectivity and memory capacity by adding optional cards. The instructions in this
section explain how to install the available cards; you can also use them to locate a card for removal.
Available internal options
• Memory cards
• Firmware cards
• Printer hard disk
• Internal Solutions Ports (ISP)
All of these options may not be available. For more information, contact the place where you purchased the printer.
Additional printer setup
29
To Next Page
Loading...
Need help?
General
