Load Manual Feeder with <size>
Try one or more of the following:
• Load the specified paper in the multipurpose feeder.
• Touch Continue to clear the message and continue printing.
If the printer finds a tray that has the correct paper type and size, then it feeds from that tray. If the printer cannot
find a tray with the correct paper type and size, then it prints from the default source.
• Cancel the current job.
Load Manual Feeder with <type> <size>
Try one or more of the following:
• Load the specified paper in the multipurpose feeder.
• Touch Continue to clear the message and continue printing.
If the printer finds a tray that has the correct paper type and size, then it feeds from that tray. If the printer cannot
find a tray with the correct paper type and size, then it prints from the default source.
• Cancel the current job.
Remove paper from standard output bin
Remove the stack of paper from the standard exit bin.
Restore Held Jobs?
Try one or more of the following:
• Touch Continue to restore all held jobs stored on the printer hard disk.
• Touch Do not restore if you do not want any print jobs to be restored.
Unsupported USB device, please remove
Remove the unrecognized USB device.
Unsupported USB hub, please remove
Remove the unrecognized USB hub.
Unsupported disk
An unsupported printer hard disk has been installed. Remove the unsupported device, and then install a supported
one.
30.yy Invalid refill, change cartridge
An unsupported, refilled toner cartridge is installed. Remove the toner cartridge, and then install a new one.
Troubleshooting
259
To Next Page
Loading...
Need help?
General
