Steps
1 Turn the mylar to nd the memory-module slot.
2 Align the notch on the memory module with the tab on the memory-module slot.
3 Slide the memory module rmly into the slot at an angle.
4 Press the memory module down until it clicks into place.
NOTE
: If you do not hear the click, remove the memory module and reinstall it.
Next steps
1 Install the base cover.
2 Follow the procedure in After working inside your computer.
Identifier GUID-D99D5F9B-0FF3-406B-A51F-FFA061BB89EA
Status Released
Coin-cell battery
Identifier GUID-9767CB19-E8EA-42DD-94FE-0EC35344A5E9
Status Released
Removing the coin-cell battery
Prerequisite
1 Follow the procedure in Before working inside your computer.
CAUTION
: Removing the coin-cell battery resets the BIOS setup program’s settings to default. It is recommended that
you note the BIOS setup program’s settings before removing the coin-cell battery.
18 Removing and installing components
To Next Page
Loading...
Need help?
General
