Issue Description of Changes Date
3. Section 2.12: updated the software high speed
counters and the maximum frequency of
hardware high speed counters C24 and C250.
4. Section 2.13: updated D1021, D1037, D1038,
D1056-D1059, D1246, and D1247. Added D1110
and D1111.
5. Section 2.16: updated the following contents:
M1077 for real-time clock, D1021 for adjustment
on input terminal response time, M1033 for
output state latched in STOP mode, COM2 in
COM port function, the availability of M1037 and
D1037 for Enable SPD function, the availability of
D1038 for communication response delay
function, M1119 for enable 2-speed output
function of DDRVI and DDRVA instructions,
D1320 to D1327 for ID of right side modules on
ES2/EX2/SS2/SA2/SX2/SE, D1386 to D1393 for
ID of left side modules on SA2/SX2/SE, M1182
and D9800 to D9879 for Mapping function of
SA2/SX2/SE for left-side high-speed special
modules, M1183 and D9900 to D9979 for Mapping
function for right-side high-speed special
modules, added state codes of DVP02PU-E2,
M1334 and M1335 for executing API59,
PLSR/DPLSR instructions for ramp-down when
the conditional contacts are closed, the
availability of M1019 for if the PLC detects that
the external 24V voltage is unstable, the error
LED flashes, and the availability of M1145 for
read MAC address from the left side network
module EN01.
6. Chapter 3: updated API50, API51, API53, API54,
API55, API57, API58, API59, API68, API78,
API79, API80, API87, API88, API113, API148,
API149, API158, API159, API207,
API175-API280, API315, API337, and API340.
Added API343-API354.
7. Section 3.2: updated the instructions OUT, SET,
and RST.
8. Section 4.1: updated communication baud rate.
Section 4.4: updated PLC device address.
9. Section 5.3: updated the contents of Repeated
Usage of Output Coil.
10. Section 6.1: updated the contents of Common
Problems and Solutions.
11. Section 6.2: updated the error codes C407, and
To Next Page
Loading...
Need help?
General
