General Information
2.4 Product Description
The SOLIVIA 10 TL / 15 TL / 20 TL / 30 TL are 3 phase grid-tied solar inverters with reactive power
control. These devices convert direct current (DC) electricity from photovoltaic power collected
from PV arrays into 3 phase alternating current (AC) to feed the excess capacity back to the local
mains electrical grid. Using cutting-edge technology allows a wide voltage input range (250~1000
V) and high performance efciency based on a user-friendly operation design. In addition, special
DSP (Digital Signal Processor) design decreases the circuit complication and electronic compo-
nents. Please note that this device does not support off-grid function. The following are the key
features of SOLIVIA 10 / 15 / 20 / 30 TL 3 phase grid-tied solar inverters.
Key Features
● Power Rating: 10 / 15 / 20 / 30 kVA
● Power Balancing (33/67) in asymmetrical dc loading situations
● 3-Phase (3-Phase + N + PE), Grid-tie, Transformerless solar inverter
● Maximum efciency: > 98.0 %
● Europe efciency: > 97.8 %
● Reactive power capability (Cap 0.80 - Ind 0.80)
● Low input current harmonic distortion (THD < 3%) @ full load
● 2 MPP Trackers
● Record up to 30 event logs.
● 5” LCD display
● EPO
The 10 TL / 15TL / 20 TL / 30 TL inverters comply with the latest country regulations and stan-
dards. Please see chapter 7 - Operating the PV Inverter for the complete list of compliance
standards.
2.5 Application & Intended Use
The operation of the solar inverter is as shown as in the gure 2.1. In order to save energy and
electricity, solar inverters convert the DC input power supplied from the PV array into three-phase
AC output power to the grid.
The solar inverter may be used in the following countries as shown:
To Next Page
Loading...
Need help?
General
