Remove the waste in the
cut waste chute section
indicated in the fi gure on the right.
(The right fi gure shows the inside of the machine after
the
waste box
was taken out.)
2
105
When a Document Jam Has Occurred
4
Troubleshooting
Put the
waste box
back in its place and close the
front door
.
J09 CHECK THE CUT WASTE CHUTE SECTION
Cut waste is jammed in the chute section because it
cannot drop in the waste box smoothly.
Follow the procedures below to remove the waste.
Open the
front door
and take out the
waste box
.
Remove the waste.
If waste remains inside the machine, remove it.
Press the STOP key to clear the error.
The DC-618 is reset and the error message is
cleared.
1
2
3
J09- * CHECK THE CUT WASTE CHUTE SECTION
Open the front door and remove
the documents from cut waste chute
section.
to clear
Make sure to set the
waste box
properly
pushing it all the way in.
IMPORTANT
To Next Page
Loading...
Need help?
General
