5.2 Setting Limits
After entering “SETUP” mode, the alarm message “SET LIMITS BEFORE OPERATING” will
appear if limits have not been set. See Section 4.3.1, Setting Position Limits, to set the
limits for the rst time. If limits have been set, this display will be bypassed and “CHANGE
DISPLAY?” will appear.
To modify previously set limits see Section 5.5, Change Settings and Section 5.5.3, Set
Valve Travel Limits.
5.3 Changing Display
The language or the contrast can be changed as follows. A passcode is not required. See
Figure 5-2.
1. At the “CHANGE DISPLAY?” prompt, answer “YES.” “CHANGE LANGUAGE?”
will appear.
2. If English is the desired language, answer “NO.” “ADJUST CONTRAST?” will
appear. Go to Step No. 4.
3. If English is not desired, answer “YES” to “CHANGE LANGUAGE?” and “DISPLAY
OTHER?” will appear. The user may change any of the words being displayed on
the message center by selecting an alternate language. “ADJUST CONTRAST?”
will appear.
4. If contrast adjustment is needed, answer “YES.” Then select NO and hold until the
desired contrast is reached. Select YES. “CHANGE DISPLAY?” appears.
5. Select NO to exit.
To Next Page
Loading...
Need help?
General
