Emerson Digitax ST User Manual

Safety
Information
Product
information
Mechanical
installation
Electrical
installation
Getting
started
Basic
parameters
Running the
motor
Optimization
EtherCAT
interface
SMARTCARD
Operation
Onboard
PLC
Advanced
parameters
Technical
Data
Diagnostics
UL listing
information
Digitax ST User Guide 163
Issue Number: 5
12.17 Menu 18: Application menu 1
12.18 Menu 19: Application menu 2
12.19 Menu 20: Application menu 3
Menu 20 parameters are transferred to the SMARTCARD when a 4yyy transfer is performed. See section 10.2.1 Writing to the SMARTCARD on
page 102 for more information.
Parameter
Range(
Ú) Default(Ö)
Type
18.01
Application menu 1 power-down
saved integer
-32,768 to +32,767 0 RW Bi NC PS
18.02 to
18.10
Application menu 1 read-only integer -32,768 to +32,767 0 RO Bi NC
18.11 to
18.30
Application menu 1 read-write integer -32,768 to +32,767 0 RW Bi US
18.31 to
18.50
Application menu 1 read-write bit OFF (0) or On (1)
0
RW Bit US
Parameter
Range(
Ú) Default(Ö)
Type
19.01
Application menu 2 power-down
saved integer
-32,768 to +32,767 0 RW Bi NC PS
19.02 to
19.10
Application menu 2 read-only integer -32,768 to +32,767 0 RO Bi NC
19.11 to
19.30
Application menu 2 read-write integer -32,768 to +32,767 0 RW Bi US
19.31 to
19.50
Application menu 2 read-write bit OFF (0) or On (1) 0 RW Bit US
Parameter
Range(
Ú) Default(Ö)
Type
20.01 to
20.20
Application menu 3 read-write integer -32,768 to +32,767 0 RW Bi NC
20.21 to
20.40
Application menu 3 read-write long
integer
-2
31
to 2
31
-1
0RWBiNC
RW Read / Write RO Read only Uni Unipolar Bi Bi-polar Bit Bit parameter Txt Text string
FI Filtered DE Destination NC Not copied RA Rating dependent PT Protected US User save PS Power down save

Emerson Digitax ST Specifications

General

Brand	Emerson
Model	Digitax ST
Category	Controller
Language	English