Emerson Process Management GmbH & Co. OHG3-14
X-STREAM XE
Short Form Manual
HASXEE-SFM-HS
05/2017
3.8 Checking the Settings
Starting with the measurement display (
2-16), pressing any key except home will access
the MAIN MENU; from here, follow these steps
:
(If the display is showing anything other than
the measurement display, press home to return
to the measurement display rst).
3.8 Checking the Settings
Set the preferred language for the software.
Note!
If you are unfamiliar with the language set:
3-13 shows the sequence of keys to set
a different language.
( )
If the system has been set up accordingly, the
code for access level 1 must be entered at this
point to enable access to the following menu.
Note!
The factory setting for this unit is "no code
required”. For ease of operation, it is recom-
mended to use the factory settings for access
codes while setting up the unit for the rst
time. In the following sections, therefore, no
more reference will be made to any need for
entering a code.
The following sections are structured so that
the user can work through them one by one
after powering up the unit. After completing
these steps, the unit will be congured to the
user’s needs and properly functioning.
Setup 1of2
Display..
Calibration/Validation..
Measurement..
In-/Outputs..
Communication..
Limit Alarms..
Installed Options..
Save-Load..
Display
Contrast..
Language: English
Phrase Version 1_6_0
Measurements..
Measurement Display..
Menu Access..
Auto Home: 10 Min
To Next Page
Loading...
Need help?
General
