Submenu Function
Status
This is information about errors that have
occurred on the projector.
This information may be needed if service
is required.
Serial Number
Displays the projector's serial number.
Lens Type
Displays the model number of your lens.
Event ID
When problems occur when the projector
and computer are connected through the
network, information on the problem is
displayed using an Event ID. See the
following page for information on
interpreting the Event ID.
s "About Event ID" p.181
HDBaseT Sig
nal Level
You can display the image signal
information from the HDBaseT port.
Light Source
Info
Light Source
Hours
Displays the operating time for each Light
Source Mode.
Estimated Re
mains
When Constant Brightness is set to On,
this displays the amount of time for which
the brightness of the light source can be
maintained.
Version Main
Video2
Displays the projector's firmware version
information.
Status Information
Displays the projector's status.
s "Reading the Status Display" p.163
* The cumulative operating time is displayed as "0H" for the first 10 hours. 10
hours and above is displayed as "10H", "11H", and so on.
Reset Menu
Submenu Function
Reset All Memo
ries
Resets all names and settings saved in Memory, Lens Position,
and Geometry Correction.
s "Memory Function" p.111
Reset All Config
You can reset all items in the Configuration menu to their default
settings.
The following items are not reset to their defaults: Input Signal,
Memory, User's Logo, all items for Network menus, Language,
Date & Time, Panel Alignment, Color Uniformity, Lens
Calibration, Color Calibration, Projector Grouping, Screen
Matching, and Color Matching.
List of Functions
146