Check Remedy
Is only one projector being used? Check if the following item is set to dark.
s Extended - Multi-Projection - Screen Matching - Brightness Settings p.133
Automatic adjustments are not performed correctly
Check Remedy
Have at least 20 minutes passed since the power was turned on? Auto adjustment does not work correctly until the temperature of the projector is stable. Perform auto adjustment 20
minutes after turning on the projector or canceling A/V Mute.
Do the Lens Type and the lens being used match? When using the following lenses, check that the Lens Type and the lens being used match. If a different lens is selected,
auto adjustment does not work correctly.
ELPLS04, ELPLU02, ELPLW04, ELPLM06, ELPLM07
s Extended - Operation - Advanced - Lens Type p.133
Is the cover of the built-in camera clean? Make sure that the cover of the built-in camera is clean. Clean the cover if it is dirty.
Is an analog signal being input? When inputting an analog signal, the color and brightness of the input image changes, and the results of adjustment may
not be applied correctly.
Has the image been corrected using Geometry Correction? Auto adjustment may not work for images corrected using Geometry Correction. Set Geometry Correction to Off or
reduce the correction range.
s Settings - Geometry Correction p.131
Is the brightness of the surroundings appropriate? If a powerful spotlight or natural light shines into the area during auto adjustment, the brightness of the surroundings
changes and auto adjustment does not operate correctly. Make sure the brightness of the surroundings does not change.
Is the blending width 15 to 45%? If the blending width in Edge Blending is 15% or less, or 45% or more, the Screen Matching function may not operate
correctly. Check the blending width.
s Extended - Multi-Projection - Edge Blending p.133
Problem Solving
176