Appendix
104
Safety Instructions for Laser Products
This projector is a Class 1 laser product that complies with IEC/EN60825-1: 2014. Make sure you follow the
instructions below.
Warning
•
Do not open the projector’s case. The projector contains a high-powered laser product.
•
Do not look directly into the projector’s light source. The powerful light emitted could cause damage to
eyesight.
•
If a problem occurs with the projector, immediately turn off the power, unplug the power plug from the
power outlet, and contact your local dealer or the contact information provided in the Epson Projector Contact
List. Continuing to use the projector when a problem has occurred could not only cause fire or electric shock,
but also damage to eyesight.
Attention
Do not disassemble the projector when disposing of it. Dispose of the projector in accordance with your
country’s regulations or local regulations.
c
•
The projector’s light source uses a laser. The laser has the following characteristics.
•
The brightness of the light source may be reduced according to the surroundings. The higher the
temperature, the greater the reduction in brightness.
•
Light source calibration may be performed when the projector is turned off to correct the white balance
of the light source and changes in the brightness level.
To Next Page
Loading...
Need help?
General
