Basic Operations
22
Projecting Images
Turning On the Projector
a
Connect the equipment to the
projector.
b
Connect using the power cord
supplied.
c
Remove the lens cap.
Attention
If the projector is turned on while the lens
cap is attached, the lens cap becomes
hot due to the light from the projector.
Make sure you remove the cap before
turning on the projector.
d
Press the standby button on the
remote control or on top of the
projector to turn it on.
Remote control Top of projector
The projector's status indicator flashes blue
as the projector warms up. Once the
projector is warmed up, the standby
indicator and the status indicator turn blue.
c
•
When Direct Power On is set to
On, you can start projecting by
simply connecting the power
cord to the projector without
having to press any buttons.
s Extended - Operation -
Direct Power On p.63
•
If you turn on Quick Startup from
the Extended menu, the
projector will be ready to project
in a just a few seconds the next
time it is turned on.
s Extended - Operation -
Quick Startup p.63
e
Turn on the connected equipment.
To Next Page
Loading...
Need help?
General
