Epson LS3-401 series User Manual

Maintenance 3. Covers
LS Rev.10 77
3.4 Connector Sub Plate
CAUTION
■
Do not remove the connector sub plate
forcibly. Removing the connector sub
plate forcibly may result in damage to the cables, disconnection, and/or
contact
failure. Damaged cables, disconnection, or contact failure is extremely
hazardous and may result in electric shock and/or improper function of the robot
system.
■
When installing the connector sub plate, b
e careful not to allow the cables to
interfere with the plate mounting and d
o not bend these cables forcibly to push
them into the cover.
Unnecessary strain on cables may result in damage to the cables, disconnection,
and/or contact failure. Damaged cables, disconnection, or contact failure
is
extremely hazardous and may result in electric shock and/or improper
function of
the robot system.
When
routing the cables, observe the cable locations after removing the
connector sub plate
. Be sure to place the cables back to their original locations.
Unscrew the Connector Sub Plate mounting
bolts and remove the plate.
The fittings position and size of the Connector
Plate are different for LS6 and LS3.
The screws’
position and size are common.
The figure is LS3.
4-M4×5
Connector
Sub Plate
3.5 User Plate
User Plate
Removal
(1)
Remove
the Arm Top Cover.
Refer to
Maintenance: 3.1 Arm Top Cover.
(2)
Unscrew the User Plate mounting bolts and
remove the plate.
2-M4
×10
User Plate
Installation
(1)
Put the U
ser Plate to the arm and secure
using
the mounting bolts.
(2)
Mount the Arm Top Cover.
Refer to Maintenance: 3.1 Arm Top Cover.

NOTE

Epson LS3-401 series Specifications

General

Brand	Epson
Model	LS3-401 series
Category	Robotics
Language	English