Images or Photos are
Printed in Unexpected
Colors
Adjust the color and then print again. The automatic
color correction feature uses the standard correction
mode in PhotoEnhance. Try another correction mode
in PhotoEnhance by selecting an option other than
Automatic as the Scene Detection setting. If the
problem continues, use any other color correction
feature other than PhotoEnhance.
The Position, Size, or
Margins of the Printout
Are Incorrect
❏ Check that the printer’s paper size setting is correct.
❏ If you want to print with no margins, make settings
for borderless printing. In the print settings for
Print Photos mode, select Borderless. If you select
a paper type that does not support borderless
printing, you cannot select Borderless. Select a
paper type that supports borderless printing.
❏ During borderless printing, the image is slightly
enlarged and the protruding area is cropped. Adjust
the amount of enlargement. In the print settings for
Print Photos mode, select Expansion, and then
select the amount of enlargement.
❏ If the margins are not correct for printing with
border, check the settings for fit frame. If you select
On as Fit Frame in the print settings for Print
Photo mode, the image is enlarged to be printed on
whole the paper and the protruding area is cropped.
❏ When printing on A5 size paper, due to the printer' s
mechanism, printouts have a margin of 10 mm
around the edges.
❏ If there are partially printed characters on the
paper, the paper width may not be recognized
correctly and printouts may not be correct.
Paper Is Smeared or
Scuffed
Problems Solutions
When horizontal banding appears
or the top or bottom of the paper is
smeared, load paper in the correct
direction and slide the edge guides
to the edges of the paper.
& “Paper Loading Direction” on
page 23
When vertical banding appears or
the paper is smeared, clean the
paper path.
& “Cleaning the Paper Path” on
page 51
❏ Place the paper on a flat surface to check if it is
curled. If it is, flatten it.
❏ Make sure that you print on the printable side of the
paper.
❏ User paper that is 0.05 to 0.6 mm thick. However,
depending on the solidity of the paper, it may still be
smeared.
❏ When performing manual 2-sided printing, make
sure that the ink is completely dry before reloading
the paper.
PM-520 Operation Guide
Solving Problems
58
To Next Page
Loading...
Need help?
General