Installation 4. First Step
T-B series Rev.1 19
4. Run the program
(1) Press F5 to run the program. (F5 is the hot key for the [Run Window] selection of the
[Run] Menu). You will see the Status window located at the bottom of the main window
showing the build operation status.
(2) During project build, your program is compiled and linked. Then communications is
established with the Manipulator and project files are sent to the Controller. If there are no
errors during build, the Run window will appear.
(3) Click the <Start> button on the Run window to run the program.
(4) The tasks like the following will be displayed in the status window.
19:32:45 Task main started
19:32:45 All tasks stopped
On the Run window, you will see the output of the print statement.