Note:
If you use binary data for the network connection, you need to set Binary to On in the PS3 Menu on the
control panel. For details about the settings, see the Network Guide. If you use the printer with a local
connection, you cannot use binary data.
Using the PostScript printer driver with Windows
To print in the PostScript mode, you will have to install the printer driver. See the appropriate sections
below for installation instructions according to the interface that you are using to print.
Installing the PostScript printer driver for the USB interface or the parallel interface
Note:
❏ Installing the printer software for Windows may require administrator privileges. If you have
problems, ask your administrator for more information.
❏ Turn off all virus protection programs before installing the printer software.
1. Make sure that the printer is turned off. Insert the printer Software Disc into your CD/DVD drive.
2. If the printer is connected to a USB interface, connect your computer to the printer with a USB
cable, then turn on the printer. If the printer is connected to a parallel interface, go to step 3.
Note for Windows Vista users:
Without the Windows driver or the Adobe PS driver, the display shows “Found New Hardware.” In
this case, click Ask me again later.
3. For WIndows 8 or 8 x64, right-click the bottom left corner of the screen, select Control Panel,
click View devices and printers, then click Add a printer button.
For Windows 7 or 7 x64, click the start button, select Devices and Printers, and click the Add a
printer button.
For Windows Vista, Vista x64, XP, XP x64, Server 2008, or Server 2008 x64, click Start, point to
Printer and Faxes, and click Add a printer in the Printer Tasks menu.
For Windows 2000, Server 2003, or Server 2003 x64, click Start, point to Settings, and click
Printers. Then double-click the Add Printer icon.
The Add Printer Wizard appears.
AL-M300/AL-M400 Series User's Guide
About the Printer Software 190
To Next Page
Loading...
Need help?
General