OptiView
TM
Series III
Getting Started Guide
36
aww46s.bmp
Figure 20. OptiView Personal Web Server Home Page
User Interface Events that will Terminate a Remote Session
The active TCP/IP session between the user interface software and the analyzer
can be severed under the following conditions:
• If IP parameters are manually changed on the analyzer and Apply is selected in
the Setup | TCP/IP screen
• If Auto Reconfigure on Network Change is checked in the TCP/IP setup screen
and the analyzer patch cable is disconnected and reconnected to another jack
• If the Ethernet link goes down due to temporary network outage
• If Rerun Auto Config is selected in the TCP/IP setup screen
• If the encryption is changed in the Setup | Remote screen
• If Find Unused IP and Apply is selected in the TCP/IP setup screen
• If Rerun Cable Test is selected
• If the Analyzer MAC address is changed in the Setup | Ethernet screen
• If Receive only, do not transmit frames is selected in the Setup | Ethernet
screen
• Changing the User Account
In the previous conditions, the popup message There are <n> user interfaces that
may lose connection to the remote OptiView Analyzer, proceed anyway? With
both the Yes and No buttons displayed.
To Next Page
Loading...
Need help?
General
