TGA300 Rev180405
21
PROGRAMMING
The following program functions are always available to view and change:
P101 - Software Program Revision Number - Read Only
P102 - Product Manufacturing Date - Read Only
P103 - Set Current Date - Read/Write
P104 - Set Current Time - Read/Write
P105 - Retrieve Fault Codes - Read Only
P106 - Engine Type Code - Read Only
Access Program Features
Note: When the program (P) code is ashing in the RPM display, press the
PRESSURE or RPM button to scroll through the P-codes or press the
SILENCE button to exit the programming mode.
1. Press the SILENCE button and hold it until the RPM display shows four dashes – – – –
and the message display shows ENTER--- CODE. Release the button.
Result: P 1 0 1 ashes in the RPM display. The message display shows the program
revision number PROG REV V500.03.
2. Press the PRESSURE button.
Result: P 1 0 2 ashes in the RPM display. The message display shows the
manufacturing date MFG DATE 16JAN'15 (ddmmm'yy).
3. Press the PRESSURE button.
Result: P 1 0 3 ashes in the RPM display. The message display shows the current date
SET DATE 16JAN'15.
4. To Change the Date: (If not, go to step 5.)
a. Press the MENU button.
Result: P 1 0 3 stops ashing. The message display shows the current date with
the year ashing.
b. Press the PRESSURE or RPM button to change the year.
c. Press the MENU button.
Result: The month ashes.
d. Press the PRESSURE or RPM button to change the month.
e. Press the MENU button.
Result: The day ashes.
f. Press the PRESSURE or RPM button to change the day.
g. Press and hold the SILENCE button to store the new date.
Result: P 1 0 4 ashes in the RPM display. The message display shows SET
TIME 10:30AM . Go to step 6.
To Next Page
Loading...
Need help?
General
