3 Copy
116
Copy
3
îš„ Auto Detect
Detects the document size automatically. The following table shows the document sizes
that can be detected automatically.
Note • If the document size cannot be detected automatically, a screen to enter the document size
appears.
The document sizes that can be automatically detected depend on [Paper Size Settings] in the System Administration mode.
For more information, refer to "5 Tools" > "Common Service Settings" > "Other Settings" > "Paper Size Settings" in the
Administrator Guide.
îš„ Standard Size
Select a document size from preset options.
You can change the sizes displayed on the screen. For information on the settings, refer to "5 Tools" > "Copy Service Settings"
> "Original Size Defaults" in the Administrator Guide.
îš„ Variable Size
Enter the desired scan size when scanning a non-standard size document or when making
copies at a size different from the original document size. You can specify a value in the
range from 15 to 432 mm for the width (X), and a value in the range from 15 to 297 mm for
the length (Y), in 1 mm increments. To help you specify values, use the scales attached on
the upper and left edges of the document glass.
Important • When the document is loaded in the document feeder, the base point in the Y (length) direction is
the center of the edge. If you specify 100 mm, the scan length will be from 50 mm above to 50 mm
below the center of the document.
Mixed Size Originals (Scanning Different Size Documents Simultaneously)
You can scan documents of various sizes simultaneously and make copies on each size or a
single size of paper. To use this feature, load the documents in the document feeder.
Important • Load documents in landscape orientation. However, always load A5 documents in portrait
orientation.
• When loading B5 documents together with A3 documents loaded in landscape orientation or A4
documents loaded in portrait orientation, load B5 documents in portrait orientation.
• If the top left corners of the documents are not aligned properly, the documents may not be
scanned correctly.
• The recommended document size combinations are A4 portrait and A3 landscape, or B5 portrait
and B4 landscape. If another combination of document sizes is used, the documents can be fed at
an angle and may not be copied properly.
Note • This feature does not appear for some models. An optional component is required. For more
information, contact our Customer Support Center.
Document Feeder Document Glass
Auto-detectable
Document Size
B5, B5 , B4, A5, A5 , A4,
A4 , A3, 8.5 x 11",
8.5 x 11" , 11 x 17", 16K ,
8K
B6, B5, B5 , B4, A6, A5, A5 ,
A4, A4 , A3
To Next Page
Loading...
Need help?
General
