Regulation
31
Before Using the Machine
1
Regulation
Radio Frequency Emissions (Class B)
Regulatory Information for RFID
Product Safety Certification (UL, CB)
This product is certified by the following agency using the safety standards listed.
This product has been tested and found to comply with the limits for a Class B
digital device, pursuant to the International Standard for Electromagnetic
Interference (CISPR Publ. 22) and Radiocommunications Act 1992 in Australia/
New Zealand. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This product generates, uses and
can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this product does cause harmful interference to radio or television
reception, which can be determined by turning this product off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
z
Reorient or relocate the receiving antenna.
z
Increase the separation between this product and the receiver.
z
Connect this product into an outlet on a circuit different from that to which the
receiver is connected.
z
Consult the dealer or an experienced radio/TV technician for help.
Changes and modifications to this product not specifically approved by Fuji Xerox
may void the user’s authority to operate this product.
This product contains Radio Frequency Identification system device (RFID) and it
is certified in compliance with applicable local laws and/or regulations.
Agency
Standard
NEMKO IEC60950-1:ed. 2
To Next Page
Loading...
Need help?
General
