5 Scan
336
Scan
5
2 Select any option.
When you select a non-standard size, specify
values for the X and Y directions.
îš„ Auto Detect
Detects the document size automatically. The following table shows the document sizes
that can be detected automatically.
Note • If the document size cannot be detected automatically, a screen to enter the document size
appears.
The standard document sizes that can be detected automatically depend on [Paper Size Settings] in the System
Administration mode. For information on [Paper Size Settings], refer to "5 Tools" > "Common Service Settings" > "Other
Settings" > "Paper Size Settings" in the Administrator Guide.
îš„ Standard Size
Allows you to select from preset sizes.
îš„ Variable Size
Allows you to enter the desired scan size when scanning a non-standard size document or
when scanning at a size different from the original document size. You can specify a value
in the range from 15 to 432 mm for the scan width (X), and a value in the range from 15 to
297 mm for the scan length (Y), in 1 mm increments. The scales attached on the upper and
left edges of the document glass are helpful for you to specify values.
Note • When [MRC High Compression] is set [On] for PDF, DocuWorks, and XPS
*
files on the [File Format]
screen, or when the [Specific Color] check box is selected, the variable ranges are 50 to 432 mm for
the scan width (X) and 50 to 297 mm for the scan length (Y), in 1 mm increments.
* : XPS stands for XML Paper Specification.
Mixed Size Originals (Scanning Different Size Documents Simultaneously)
When loading documents in the document feeder, you can simultaneously scan different
size documents with the respective sizes and copy. You can also specify a size to scan
different size documents with the same size.
Important • When you select [Color] in [Color Scanning], and [2 Sided] in [2 Sided Scanning], set [Resolution] to
[400dpi] or lower.
• When you select [2 Sided] in [2 Sided Scanning] to scan A3 documents, set [Resolution] to [400 dpi]
or lower. Selecting [600 dpi] will cause an error message to be displayed.
• Always load A5 documents in portrait orientation.
• When loading B5 documents together with A3 documents loaded in landscape orientation or A4
documents loaded in portrait orientation, load the B5 documents in portrait orientation.
• When loading documents, align the top left corners of the documents properly. Otherwise, a paper
jam may occur.
Document feeder Document glass
Auto-detectable
Document Size
B5, B5 , B4, A5, A5 , A4, A4 , A3,
8.5 x 11", 8.5 x 11" ,
11 x 17", 16K , 8K
B6, B5, B5 , B4, A6, A5, A5 , A4,
A4 , A3
To Next Page
Loading...
Need help?
General
