Manufacturer’s no tes
FCC Regulatory information for notebooks with radio device
Regulatoryinf ormation
Federal Communication s Commission statement
This device complies with Part 15 of FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause interference, and
(2) this device must accept any interference, including interference that m ay
cause undesired operation of this device.
FCC Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursu ant to Part 15 of the FCC Rules. These limits are designed to provide re asonable
protection against harmful interference in a residential installation. T his equipment generates,
uses, and can radiate radio frequen cy energy. If not installed and used in a ccord ance with
the instructions, it may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equ ipment off and on, the user is encouraged to try to
correct the interference by one or more of t he following measures:
1. Reorient or relocate th e receiving antenna.
2. Increase the distance betw een the equipment and the receiver.
3. Connect the equipment to an outlet on a circuit different fro m the o ne the receiver is connected to.
4. Consult the dealer or an experienced radio/TV technician for help.
Please no te the following regulatory information related to the optional radio device.
FCC Radio Frequency Exposure statement
This radio device has been evaluated unde r FCC Bulletin OET 65C and found compliant w ith the
requirements as set forth in CFR 47 Sections 2.1 091, 2.1093, and 15.247 (b) (4) addressing RF
Exposure from r adio frequency devices. The radiated output power o f this radio device is far below
the FCC radio frequ ency exposure limits. Nevertheless, this device shall be used in such a manner
that the potential for human contact during normal operation is minimized. When using this device, a
certain separation distance between antenna and nearby persons must be maintained to ensure RF
exposure compliance. In order to comply with RF exposure limits established in the ANSI C95.1
standards, the distance between the antennas an d the user should not be less than 20 cm (8 inch es).
Regulatory Notes and Statements
Radio device, health and authorisation for use
Radio-frequency electromagnetic energy is emitted from the wireless devices. The energy levels
of these emissions, however, are far m uch less than the electromagn etic energy emissions from
wireless devices such as mobile phones. Radio devices are safe for use b y consumers because
they operate within the guidelines found in radio frequency safety standards and recommendations.
The use of the radio devices m ay be restricted in some situations or environments, such as:
• on board an airplane, or
• in an explosive environment, or
• in situations where the interference risk to othe r devices or services is
perceived or identified as harmful.
In cases in which the policy rega rding use of radio devices in specific environments is not
clear ( e.g., airports, hospitals, chemical/oil/gas industrial plants, private buildings), obtain
authorization to use these devices prior to operating the equipment.
82 Fujitsu Technology Solutions
To Next Page
Loading...
Need help?
General