1. OPERATION
1-26
1.17.3 Fish info
1. Press the MENU/ESC key to open the menu.
2. Select [Display], then press the KNOB.
3. Select [ACCU-FISH], then press the KNOB to show the [ACCU-FISH] menu.
4. Select [Fish Info], then press the KNOB.
5. Select [Fish Size] or [Depth] as appropriate, then press the
KNOB.
Note 1: You can show the fish info figure alone (without fish symbol) by turning off
[Fish Symbols] on the [Display] menu.
Note 2: You can show the fish info in small or large characters, with [Info Size] on
the [ACCU-FISH] menu.
1.17.4 Restrict the fish symbol display
When multiple fish symbols are displayed, the screen becomes cumbersome. You
can limit the display of fish symbols by adjusting the required single fish size.
1. Press the MENU/ESC key to open the menu.
2. Select [Display], then press the KNOB.
3. Select [ACCU-FISH], then press the KNOB.
4. Select [Fish Detect From], then press the KNOB.
5. Set the size value, then press the KNOB.
For example, if you set [Fish Detect From] to 10 cm and [Fish Detect Span] to +50
cm, fish symbols other than those between 10 and 60 cm will not be displayed on
the screen.
6. Select [Fish Detect Span], then press the KNOB.
7. Set the span value, then press the KNOB.
8. Press the MENU/ESC key twice to close the window.
Fish size or depth is
shown in red.
To Next Page
Loading...
