2. SYSTEM MENU
2-4
2.6.2 [Data Source] setting window
The [Data Source] setting window allows you to adjust settings related to various data
sources.
Menu Item Description
[SOG] Select the sensor to use as data source for SOG, STW, Nav Data, heading,
position, wind Spd/Dir, atmospheric pressure, water temperature and heave.
1) Turn on all connected sensors.
2) Select the desired data for data source and
press the KNOB.
The data source selection window appears.
The figure on the right shows an example of
when [Heading] is selected.
3) Select one of the following data sources and
press the KNOB.
The choices displayed in the data source selection window depend on the
selection of step 2) above.
• [-------]: Unselected.
• [Port1] (FCV-800 only): Import data from the NMEA0183 device connected to
the [PWR/KP/NMEA0183] port.
• [Own], [Own1] (FCV-800 only): Import data from the transducer connected to
the [XDR] (FCV-600) or [XDR1] (FCV-800) port.
• [Own2] (FCV-800 only): Import data from the transducer connected to the
[XDR2] port.
• NMEA2000 device name/ CAN ID: Import data from the NMEA2000 device
connected to the [NMEA2000] port. If multiple devices are connected to the
same network, the names of all devices will be displayed. Select the device
to be used as the data source.
4) Repeat step 2) and 3) to set all data sources.
[STW]
[Nav Data]
[Heading]
[Position]
[Wind Spd/Dir]
[Atmos Press.]
[Water Temp]
[Heave]
㻼㻳㻙㻣㻜㻜䚷㻝㻠㻥㻡㻤
CAN ID name
NMEA2000 device name
To Next Page
Loading...
Need help?
General
