8. NBDP PREPARATIONS
8-6
8. Press the ↓ key to select [Stop Time]. Enter stop time, in 24-hour notation.
9. Press the ↓ key to select [Receive/Send]. Select operation category; [Receive] or
[Send]. If you select [Send], go to step 10. For [Receive], go to step 12.
10. For [Send], insert the floppy disk or the SD card to the drive then press the ↓ key
to select [File to Send].
11. Press the → key to open the TX window, select a file, then press the Enter key
twice.
12. Press the Enter key. A confirmation message appears.
13. Press the Enter key. The operation name appears in [Timer Operation List].
14. To enter another timer program, press the Enter key twice and repeat steps 3 to
13.
15. Press the Esc key to close the menu.
8.4.2 How to edit/delete timer programs
1. Press the function key F5 then the 2 key to open the [Timer Operation Entry]
screen.
2. Press the ↓ key to select a timer program name from the [Timer Operation List].
3. Press the → key then the ↓ key to select [Change] and press the Enter key.
4. Do one of the following;
Edit program: Use the ↓, ↑ and the Backspace keys to make corrections.
Delete program: Erase operation name with the Backspace key.
5. Press the Enter key twice.
6. Press the Esc key.
8.5 Scan Channel Groups
You can store up to 10 scan groups, 20 channels per group.
The NBDP terminal unit can control radio equipment through channel scanning. In the
FEC mode, the radio equipment scans a number of channels (according to your se-
lection), stopping when an synchronous code is found. In the ARQ mode it stops when
your own ID code is detected in an incoming signal. Also, in the ARQ mode, the trans-
mitter is then tuned to the corresponding transmitter frequency, the communication
link is established and the traffic is automatically exchanged. Scanning resumes once
the link is disconnected.
To Next Page
Loading...
Need help?
General
