8. NBDP PREPARATIONS
8-8
8. Enter the channel number (ITU or user channels) then press the → key to select
[Scan].
Note: If you enter an invalid channel, the message "Channel by that number does
not exist. Press any key to escape." appears. Press any key then enter a valid
channel.
9. Press the ↓ key to select line No. 2. Enter a channel number.
10. Enter other channel numbers then press the Enter key. A confirmation message
appears.
11. Press the Enter key again to save the data. The group name is displayed in the
[Scanning Group List] window.
12. To continue, press the Enter key twice then repeat steps 3 to 11.
13. Press the Esc key to close the menu.
Note 1: An ARQ from another station continues for 56 seconds. However, you
cannot receive via ARQ if the number of registered scan frequencies multiplied by
the channel dwell time is greater than 56 seconds.
Note 2: The selective FEC mode requires authentication of call ID. However, you
cannot receive via the selective FEC mode if the Call ID is not received with the
frequency for scan detention time. If you might be called via the selective FEC
mode, wait to receive the call on a single frequency, which you can set with the
[Set Frequency] in the [Operate] menu.
8.5.2 How to edit/delete scan channel groups
1. Press the function key F5 then the 3 key to open the [Scan Entry] screen.
2. Press the ↓ key to select scan group name from the [Scanning Group List].
3. Press the → key then the ↓ key to select [Change] and press the Enter key.
4. Press the ↓ key to place the cursor on the field (channel) to change.
5. Do one of the following:
Edit channels: Press the Backspace key to delete the channel number then enter
a new channel number.
Add channels: Enter a channel number on a blank line.
Delete scan group: Delete the group name with the Backspace key.
Disable channels temporarily: Press the ← key to underline [Pass].
6. Press the Enter key twice.
7. Press the Esc key to close the menu.
8.6 How to Change the Window Color
You can select and change the window color.
8.6.1 IB-583
1. Press the function key F6 to open the [System] menu.
2. Press the → key to select [Change] from [Setup].
To Next Page
Loading...
Need help?
General
