Furuno TZT2BB User Manual

5. ROUTES
5-14
5.11.7 XTE lines
The color of the XTE line is red for the port side, green for the
starboard side. You can show or hide these lines and set their
distance from own ship as follows.
1. Open the home screen, then tap [Settings] - [Routes].
2. Turn [Display XTE Lines] on or off. For [ON], go to the next
step. For [OFF], tap the close button to finish.
3. Tap [XTE Value] to display the software keyboard
4. Set the distance of the XTE lines from your ship then tap [].
The XTE alarm sounds (if active) when your ship veers off
course by the amount set here.
5. Tap the close button to finish.
5.11.8 Waypoint arrival notification
The waypoint arrival notification feature releases audio and visual notifications when
your ship reaches a go to point. For the arrival timing, see subsection 5.11.5. The no-
tification message "Waypoint Crossing" appears. Activate or deactivate this feature as
follows.
1. Open the home screen, then tap [Settings] - [Routes].
2. Turn [Waypoint Crossing Notification] on or off.
3. Tap the close button to finish.
5.11.9 End of route notification
The end of route notification feature releases audio and visual notifications when your
ship reaches the end of a route. For the arrival timing, see subsection 5.11.5. The no-
tification message "End of Route" appears. Activate or deactivate this feature as fol-
lows.
1. Open the home screen, then tap [Settings] - [Routes].
2. Turn [End of Route Notification] on or off.
3. Tap the close button to finish.
5.11.10 How to change the autopilot’s operation once you arrive
When you arrive at the route destination, you can keep the destination and route ac-
tive, or stop autopilot navigation.
1. Open the home screen, then tap [Settings] - [Routes].
2. Tap [End of Route Operation].
3. Tap [Stop Navigation], or [Continue Navigation], as required.
4. Tap the close button to finish.
XTE lines
(Red: port,
Green: starboard)

Furuno TZT2BB Specifications

General

Brand	Furuno
Model	TZT2BB
Category	Monitor
Language	English