2. PLOTTER
2-8
2.7 How to Find the Range and Bearing Between
Two Locations
The [Distance] item in the slide-out menu measures the range and bearing between
any two locations on your chart. Range and bearing between the two locations are dig-
itally indicated on the screen.
1. Open the slide-out menu.
2. Tap [Distance].
A dashed line runs between the start location and the 2nd location. The range,
bearing, SOG, and TTG to the 2nd location is shown at the top of the screen.
3. To change the location of either point, drag and drop.
4. To quit the distance measurement, tap [Cancel Ruler] at the top right-hand corner
of the screen.
Range Bearing Speed Over the Ground TTG
Starting locationStarting location
2nd location2nd location
Icon
Drag to change location.
Icon
Drag to change location.
To Next Page
Need help?
General