1. SYSTEM INTRODUCTION
1-25
1.11 MicroSD Cards/SD Cards
This equipment uses two types of microSD cards/SD cards, chart cards and data
cards. The chart cards contain charts and the data cards store plotter-related data
such as tracks, routes, points and generic data such as menu settings. (The microSD
card drive on the TZTL12F/TZTL15F display is for chart cards only. Use the SD card
unit for data cards and chart cards.) Set and remove the card as shown below. Secure
Digital Extended Capacity (SDXC) cards can also be used.
Note: SD cards are available for use with the TZT2BB only.
How to insert a microSD card/SD card
Before inserting a chart card in the multi function display, turn off the power.
How to format a microSD card/SD card
You do not normally need to format a data microSD card/SD card. If the card becomes
unreadable, format the card with a formatting program that is compatible with the
specifications of the card.
How to remove a microSD card/SD card
1) Open the card drive cover.
2) Push the card to release the card from the card drive.
3) Remove the card with your fingers then close the lid (cover).
Unfasten two
screws.
SD card unit (SDU-001)Chart card drive (multi function display)
Open cover.
Push card
into a slot
and close
cover.
Protective
cover
Remove the
protective cover
Install the chart
card in the left slot.
Install the data card in the right slot.
Note: After installing the chart card, be sure to replace the protective cover.
Note: The TZT2BB does not recognize cards that are locked. Before inserting a card, check the
tab on the side of the card to be sure that the card is unlocked.
Peel the card slot
cover from the top end
to show the card slots.
For chart cards
For tracks, routes, points
and settings data cards
For TZTL12F/TZTL15FFor TZTL12F/TZTL15F
For TZT2BBFor TZT2BB
Push card into slot
and close cover.