Garmin G1000 Pilot’s Guide for the Piper PA-32 Saratoga
190-02692-00 Rev. A
96
ENGINE INDICATION SYSTEM
SYSTEM
OVERVIEW
FLIGHT
INSTRUMENTS
EIS
AUDIO PANEL
& CNS
FLIGHT
MANAGEMENT
HAZARD
AVOIDANCE
AFCS
ADDITIONAL
FEATURES
APPENDICESINDEX
ENGINE SOFTKEYS (REVERSIONARY MODE)
Level 1 Level 2 Level 3 Description
ENGINE Displays on the EIS: The Engine Manifold Pressure, Tachometer, Fuel Quantity, Fuel Flow, Oil
Pressure, Oil Temperature, Exhaust Gas Temperature, Cylinder Head Temperature, Emergency
Battery voltage, Essential Buss voltage, and Main (or Standby) Alternator amperes.
LEAN Displays on the EIS: The Engine Manifold Pressure, Tachometer, Fuel Quantity, Fuel Flow, Exhaust
Gas Temperature and lean indication for each cylinder, and Cylinder Head Temperature and lean
indications for each cylinder.
CYL SLCT Displays and cycles through the cylinders and obtain information about a cylinder, highlighted in
cyan on the bar graph(s)
ASSIST Displays the temperature deviation from peak (DPEAK) in degrees Fahrenheit below the EGT
display for the peaked cylinder.
SYSTEM Displays on the EIS: The Engine Manifold Pressure, Tachometer, Fuel Quantity, Fuel Flow, Fuel
Calculation information, Oil Pressure and Temperature, Cabin Temperature, Battery amperes,
Emergency Battery voltage, Essential Buss voltage, and Main (or Standby) Alternator amperes.
DEC FUEL Decreases the displayed fuel remaining (GAL REM) in 1 gal increments.
INC FUEL Increases the displayed fuel remaining (GAL REM) in 1 gal increments.
RST FUEL Resets displayed fuel remaining (GAL REM) to maximum fuel capacity. Resets fuel used (GAL
USED) to zero.
BACK Returns the EIS back to the ENGINE Softkey display information.
Table 3-3 Engine Softkeys (Normally Aspirated)
Level 1 Level 2 Level 3 Description
ENGINE Displays on the EIS: The Engine Manifold Pressure, Tachometer, Fuel Quantity, Fuel Flow, Oil
Pressure, Oil Temperature, Turbo Inlet Temperature, Cylinder Head Temperature, Emergency
Battery voltage, Essential Buss voltage, and Main (or Standby) Alternator amperes.
LEAN Displays on the EIS: The Engine Manifold Pressure, Tachometer, Fuel Quantity, Fuel Flow, Turbo
Inlet Temperature, and Cylinder Head Temperature and lean indications for each cylinder.
CYL SLCT Cycles through the cylinders and obtain information about a cylinder, highlighted in cyan on the
bar graph(s)
SYSTEM Displays on the EIS: The Engine Manifold Pressure, Tachometer, Fuel Quantity, Fuel Flow, Fuel
Calculation information, Oil Pressure and Temperature, Cabin Temperature, Battery amperes,
Emergency Battery voltage, Essential Buss voltage, and Main (or Standby) Alternator amperes.
DEC FUEL Decreases the displayed fuel remaining (GAL REM) in 1 gal increments.
INC FUEL Increases the displayed fuel remaining (GAL REM) in 1 gal increments.
RST FUEL Resets displayed fuel remaining (GAL REM) to maximum fuel capacity. Resets fuel used (GAL
USED) to zero.
BACK Returns the EIS back to the ENGINE Softkey display information.
Table 3-4 Engine Softkeys (Turbocharged)